Procedure - Manual - IoT2050 Industrial Edge Device - SIMATIC IoT2050 - Industrial Edge

1. Run MobaXterm and see its main window.

2. Press "Session" button at the upper left corner of the window.

1. In the session dialog press "Serial" button

   

2. In the "Serial Session" dialog choose appropriate "Serial port" and "Speed (bps)" parameters.

3. In the "Serial port" combo box please choose "Prolific USB-to-Serial Comm Port" item. Before the text there will be "COM specification". Depending on your laptop's USB port it may be COM1, COM2, ... etc. In our example it is seen as COM3 below.

4. In the "Speed (bps)" combo box please choose 115200 as in the example below.

   

5. Press "OK". The session will be created and displayed in the "sessions" part of the main window.

   

6. Power up the IOT2050 Edge device.

7. Double click the created session. The following output will be displayed

   

   This means IOT2050 Edge device is booting. After booting you will be asked to enter your username.

   

If you use a Service Stick you will see the main window of Service Stick like below.

If you do not use MobaXterm full screen while Service Stick is plugged, the main window of Service Stick would be displayed as follows:

Therefore, we recommend the full screen usage especially when the Service Stick USB stick is plugged.