Procedure - Manual - SIMATIC S7 Connector - Industrial Edge - Industrial Edge App

To deploy a data point, follow these steps:

1. Launch the SIMATIC S7 Connector application.
   The Configurator home page is displayed.
2. Select the data points that you want to deploy.
3. Click Deploy in the upper-right corner.
   The Deploy dialog box is displayed as follows:
   
4. Select the required IED on which you want to deploy the changes.

5. Click Deploy.
   The Configurator takes a while to deploy the project, and a success message is displayed subsequently. The data points are deployed and downloaded, and a green check mark is displayed next to the selected data points.

   NOTE

   • You can deploy the changes only when the IEDs are in Online state.
   • Mass deployment feature (deploying to multiple IEDs) is available only when the runtime for the selected IEDs is not running.
   • Before performing mass deployment, you must ensure that same user credentials and topic are already added in the Databus Configurator for all the selected IEDs where you want to perform the mass deployment.
   • When the runtime is running and deploy fails, the state of tags/connections for which deploy failed is set to partially deployed state.